Difference between revisions of "Networking"

From SkullSpace Wiki
Jump to navigation Jump to search
(networking gear update)
C (talk)
Line 1: Line 1:
−
== Network map ==
+
== Network status ==
 +
Skullspace internal network is fine but needs better organization and documentation, see tasks section. Internet connection has occasional issues when the SkSp or AW routers have trouble getting an IP - this is being troubleshooted.
  
−
*Internet from VOI (wifi-based, tested 60mbit down 20mbit up to Speedtest.net Winnipeg) comes from a drop in the middle of the space, through one of the red-ziptie lines below the drop, to the server room.
+
== high-level description ==
−
*There, it goes through a 5-port gigabit switch, to a Linksys WRT54G2 router (External IP 206.220.194.176 internal 192.168.1.1), which is also connected to a 24-port Intel 510T switch.
+
Internet is furnished by VOI, goes to the internet switch where multiples routers and servers connect. There is a Linksys router for the main Skullspace network; this connects to a 24-port gigabit switch which has a few sub-switches in different rooms. There are APs around skullspace with the "skullspace"  SSID and some near the fire escape connected to dishes outside.
−
*Another cable from the internet-side switch goes to a D-link DIR-655 N in Assentworks for their network.
 
−
*A Belkin wireless-N router in the lounge room is setup as an AP, connected to the Intel switch.
 
  
−
*Speedtests: on wifi: 40mbit down on Dlink, 33mbit down on Linksys; 9mbit up on both (dlink was 1mbit up before QOS was turned off.) Hardwired: maximum 50mbit down 16mbit up on the Linksys.
 
  
 +
== Internet feeds ==
 +
Primary: Internet from VOI (wifi-based Ubiquity NB5, tested 60mbit down 20mbit up to Speedtest.net Winnipeg) comes from a drop in the middle of the space, connects to line #?? below the drop, goes to the server room where its PoE is; goes to the primary internet switch.
 +
== Network hardware ==
 +
Linksys WRT54G2 router (External IP 206.220.194.191 internal 192.168.1.1)  G wireless has been tested to 33mbit.
 +
A Belkin wireless-N router in the lounge room is setup as an AP and switch, connected to the main SkSp network
  
 
== Wiring ==
 
== Wiring ==
−
All wires connect back to the Intel switch unless otherwise indicated.
+
Catalog needs to be input here
−
 
 
−
*2 lines (white cable, red zipties) from server room to internet entry point at the middle of the space. One is the internet feed, warning - it is PoE (24V? on the spare pairs).
 
−
*2 lines (white cable, green zipties) from server room to desk/work area at NE of building.
 
−
*6 lines (orange cable) from server room to: junk/LAN party room, 2 poles of lounge room, Assentworks SE corner, Assentworks SW corner, electrical panel.
 
−
*2 lines (orange cable) to desk in learning room and vending machine.
 
−
*3 lines (white cable) to both sides of bench in workshop, and to King's Head AP at fire escape (this last one is PoE, 48V).
 
  
 
The above runs were conservative - in many cases only a single drop because we were low on cat5, when I'd have preferred to put 2 drops to be prepared for the future - but they still total up to 2000ft of cable, and ~15hrs of wiring work.
 
The above runs were conservative - in many cases only a single drop because we were low on cat5, when I'd have preferred to put 2 drops to be prepared for the future - but they still total up to 2000ft of cable, and ~15hrs of wiring work.

Revision as of 21:42, 17 January 2012

Network status

Skullspace internal network is fine but needs better organization and documentation, see tasks section. Internet connection has occasional issues when the SkSp or AW routers have trouble getting an IP - this is being troubleshooted.

high-level description

Internet is furnished by VOI, goes to the internet switch where multiples routers and servers connect. There is a Linksys router for the main Skullspace network; this connects to a 24-port gigabit switch which has a few sub-switches in different rooms. There are APs around skullspace with the "skullspace" SSID and some near the fire escape connected to dishes outside.


Internet feeds

Primary: Internet from VOI (wifi-based Ubiquity NB5, tested 60mbit down 20mbit up to Speedtest.net Winnipeg) comes from a drop in the middle of the space, connects to line #?? below the drop, goes to the server room where its PoE is; goes to the primary internet switch.

Network hardware

Linksys WRT54G2 router (External IP 206.220.194.191 internal 192.168.1.1) G wireless has been tested to 33mbit. A Belkin wireless-N router in the lounge room is setup as an AP and switch, connected to the main SkSp network

Wiring

Catalog needs to be input here

The above runs were conservative - in many cases only a single drop because we were low on cat5, when I'd have preferred to put 2 drops to be prepared for the future - but they still total up to 2000ft of cable, and ~15hrs of wiring work.

King's Head Pub AP

A popular meeting space in Winnipeg, 1 block away from Skullspace, which doesn't have wifi - but we can see the rear of its brick building from Skullspace. So we used a donated Cisco Aironet 1100AP, modified it for external antenna connection, ran some LMR400 cable outside the fire escape door and up the fire escape ladder, and pointed a 19dbi dish towards the pub. SSID is SkullSpace-dish-aimedatKingsHead, ask a member for the password. It doesn't work at all in the south main-floor area, but it does have coverage in most parts of the north main-floor area. Speedtests: 1 to 4mbit down on a laptop with a good wireless card (Atheros N). I tried to replace the Cisco 802.11B card in the AP with a 802.11G upgrade card (AIR-MP21G-A-K9), but it became almost impossible to connect - likely because Cisco was becoming involved with Broadcom at the time that G card was made, who's known for the low sensitivity and receiver quality of their chipsets.

Plans to increase coverage:

  • upgrade 19dbi to 24dbi antenna - I have some, but they're huge and a lot of windload to put on the fire escape ladder (especially if they ice up in the winter), would prefer a roofmount pad. We'd need to calculate that the smaller beamwidth of the higher-gain antennas doesn't lose coverage of the edges of the King's Head - this math would be size of Kings's Head building x distance = degrees of view?
  • add antenna receive diversity - again, the second antenna would be better on an additional (spaced farther apart horizontally) roofmount pad; vertical diversity on the fire escape ladder wouldn't help as much.
  • move antenna - currently the view (all the way up the fire escape ladder) to the front of King's Head is blocked by a concrete building. 5-10ft south on a roofmount would be ideal.
  • add an amplifier or a higher-power radio. The Cisco puts out 100mw, have a 500mw amplifier. Since this isn't an omni but a highly directional antenna, we could maybe classify it under the rule that allows 24dbi gain and 24dbm power output (500mw is 27dbm, but we're losing 3 db in the 40ft of LMR cable and connections, which brings us nicely to 24dbm).
  • ground the fire escape ladder - I'm careful about grounding all antenna structures.
  • check that the antenna and LMR cable/connections are running at full efficiency - this is old gear from my garage and I can't guarantee that they were.

Signal in the North-main floor area is currently -82 to -87 when connection is possible, with all of the above I'd hope to get it to mid-70s numbers which should allow for pretty good coverage, considering we're a block away and going through thick brick/concrete.


Linksys Port Forwarding entries

If ever we need to reset the Linksys, these will be put back in, so keep them updated.

  • webcam1 port 31337 tcp to 192.168.1.250
  • webcam2 port 9001 both to 192.168.1.250
  • webcam3 port 31338 tcp to 192.168.1.251
  • webcam4 port 80 tcp to 192.168.1.124
  • MUMD port 22(SSH) tcp to 192.168.1.10
  • Russtot port 993 tcp to 192.168.1.99
  • Russvent port 3748 tcp/udp to 192.168.1.99

Network Map

  • 192.168.1.1 Dlink Router in server room (on loan by Mark)
  • 192.168.1.2 Reserved
  • 192.168.1.3 Belkin N Router in Lounge area
  • 192.168.1.4 King's Head AP
  • 192.168.1.5 Reserved
  • 192.168.1.6 Intel 510T switch
  • 192.168.1.7 South-pointing AP
  • 192.168.1.8 HP parallel print server
  • 192.168.1.9 MUMD host distro
  • 192.168.1.10 MUMD latest Ubuntu (currently natty 11.04)
  • 192.168.1.11 MUMD Debian 6.0 (wheezy)
  • 192.168.1.12 Samsung CLP-310N printer
  • 192.168.1.13 MUMD Debian stable, system services
  • 192.168.1.15 Cisco switch
  • 192.168.1.16 Netgear switch
  • 192.168.1.17 Cisco 4924 Switch-1
  • 192.168.1.18 Cisco 4924 Switch-2
  • 192.168.1.19 Linksys wireless access point, in server room -- suspected to be broken, both as a router and as wireless access point, unplugged, please test offsite.
  • 192.168.1.42 Andrew's server - internal interface
  • 192.168.1.69 Ayecee's server - internal interface
  • 192.168.1.99 Russ' netbook
  • 192.168.1.100-199 Linksys DHCP space
  • 192.168.200-220 Network lab address space
  • 192.168.1.250 Old crappy cameras (currently offline)
  • 192.168.1.251 New Camera
  • 192.168.1.252 Cameras


Hardware

HP Proliant ML350 4U rackmount

  • Connected to internet
  • Admin contact: ayecee@gmail.com

Dell PowerEdge 1750 1U rackmount

White desktop with front game port

  • Connected to the internet
  • Admin contact: ben@benbergman.ca
  • MAC: 00:4f:49:0b:f7:fb
  • IP: 206.220.194.212

Keys

The following members have keys to the server room:

  • Ron Bowes
  • Andrew Orr
  • Mak Kolybabi
  • Colin Stanners

If you'd like a key, and you have a reason, let me know and I'll make sure you get one! --Ron

Retrieved from "https://wiki.skullspace.ca/index.php?title=Networking&oldid=1259"